Page 1 of 1
Trumpy Bolts
Posted: Thu Aug 20, 2015 11:04 am
by XorA
Finally arrived so I can actually use it
Re: Trumpy Bolts
Posted: Thu Aug 20, 2015 4:41 pm
by Ralf R.
Means nothing to me.... A TrumpCard?
(Oh, I thought the OT here is just for pretty good meals....
)
Re: Trumpy Bolts
Posted: Thu Aug 20, 2015 11:17 pm
by XorA
I have been annoying rob and VP on chat waiting from bolts for my trump card to connect the 7805 to the heatsink so I can actually use it!
Re: Trumpy Bolts
Posted: Fri Aug 21, 2015 11:07 am
by 1024MAK
A M3 nut and a M3 x 10mm or M3 x 6mm (depends on if heatsink fitted) machine screw normally work well
Mark
Re: Trumpy Bolts
Posted: Fri Aug 21, 2015 11:39 am
by XorA
1024MAK wrote:A M3 nut and a M3 x 10mm or M3 x 6mm (depends on if heatsink fitted) machine screw normally work well
Mark
According to my calipers the hole in Trumpcard is smaller than an M2, I used M1.6 bolts.
Re: Trumpy Bolts
Posted: Fri Aug 21, 2015 12:04 pm
by 1024MAK
Ahh, what a strange size PCB hole for a regulator
Is a heatsink fitted?
Mark
Re: Trumpy Bolts
Posted: Fri Aug 21, 2015 4:00 pm
by XorA
Yes the heatsink is also the vanity cover.
And yes its a very odd choice of hole, there is penty of room on PCB there for a M3 hole through and the casing would only have needed a lip a little extended.
Hopefully you can just see the regulator peeping out.
Re: Trumpy Bolts
Posted: Fri Aug 21, 2015 4:23 pm
by Ralf R.
Not very "Miracle-alike"....
Re: Trumpy Bolts
Posted: Fri Aug 21, 2015 4:42 pm
by XorA
Re: Trumpy Bolts
Posted: Fri Aug 21, 2015 6:36 pm
by Ralf R.
I've seen it from the first pic, thanks anyway, but it's not very "Miracle-alike", isn't it?
Interesting to see, I never realized, that the TC isn't an SQB, no PAR port.