Weak ribbon cable pins of MDV units

Nagging hardware related question? Post here!
User avatar
Cristian
Gold Card
Posts: 463
Joined: Mon Feb 16, 2015 1:40 pm
Location: Veneto

Weak ribbon cable pins of MDV units

Postby Cristian » Sun Feb 11, 2018 1:12 pm

Almost everybody knows the infamous weak pins of the microdrives ribbon cable. But is there a straightforward way to replace them with a sort of plug with rigid pins?


RWAP
RWAP Master
Posts: 2445
Joined: Sun Nov 28, 2010 4:51 pm
Location: Stone, United Kingdom
Contact:

Re: Weak ribbon cable pins of MDV units

Postby RWAP » Sun Feb 11, 2018 2:16 pm

I tend to use a strip cut from an a chip socket, insert the cable pins into that strip and then insert the 2 strips into the QL motherboard.

It makes it easier


User avatar
Dave
SandySuperQDave
Posts: 1981
Joined: Sat Jan 22, 2011 6:52 am
Location: Austin, TX
Contact:

Re: Weak ribbon cable pins of MDV units

Postby Dave » Sun Feb 11, 2018 5:06 pm

This is what I do. Turned pin IC sockets. Put the wire into the strip, solder, and then you'll have two rigid rows that are MUCH easier to insert.


User avatar
Cristian
Gold Card
Posts: 463
Joined: Mon Feb 16, 2015 1:40 pm
Location: Veneto

Re: Weak ribbon cable pins of MDV units

Postby Cristian » Sun Feb 11, 2018 7:37 pm

Thank you very much Rich and Dave for your suggestions. It's a very useful and effective solution!



Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest