gst q disk clone problem......

Nagging hardware related question? Post here!
Post Reply
nikosdoykas
Over Heated PSU
Posts: 134
Joined: Tue Oct 09, 2018 4:20 am

gst q disk clone problem......

Post by nikosdoykas »

so the pcb of the gst qdisk came and i assebled.... old chips from mitsubishi... i download the 1.16 rom and write on a 27c64 and put the qdisk on ql....
the result BLACK SCREEN...... SO i mesure the dsmc ant was alwayw high... i remove the bs250 and switch the ql on.....
now i can se the the think on ql BUT I PRESS F2 AND QL DO NOTHING.... SO
Ι think that the schem was wrong.... and it was not the 8 from the 74ls10 that has always 5 volt on base of the bs but the 8 from the 74ls04 thaits inverted
i take the base of the bs250 from that pin...f2 ihear the mdv1 spining... lets try a floppy... stugart ds0
its green light glow always but not motor on..... i have a stugart ds1 light was off i command dir flp2_ the light turn on but not motor....it always high...on 16 in of the connector
i make many masuments all the d0-d7 has low an high an the a0a12 works olso the a13 make the ce(chip enable and it works)
but nothing after that i try olso an AMIGA drive.... nothing ...
any thouts?

so acrually something is wrong with shem.....
but id one has the 1.18 rom or 1.19 that the shem says will be nice to tryit....
Attachments
CST Schematic.jpg
175418894_805783180321042_6208013832334091711_n.jpg
1.png


Post Reply