yes is true! see this picture: http://www.fruitcake.plus.com/Sinclair/Spectrum128/SCARTCable/Spectrum128SCARTCableQL.htm
Search found 185 matches
It’s possible because the video signals from that ULA are direct and not protected to rgb socket! If you have some experience with soldering you can attach some zener diodes to protect output pins.
D26 is the diode that bring negative rail to -12 volt regulator ic so is it possible that you have checked the ac voltage that feed power supply; try check the c40 condensator if it has 0 and -12 volt, but in effect that voltage is needed only for rs232 ports so is not the main problem ....
Hi, on the voltage regulator you must have 9-10 volt on right pin that is the output voltage of transformer and 5 volt on left pin to drive all chips on motherboard, also you can check pin 14 of video driver chip ( the one below modulator) where you must have 12 volt.
Hi, if you search into forum you will find a topic about an interface to connect a ps2 mouse and also in Dilwyn web site you will find a lot of infos about your request.
- Sun May 27, 2018 8:22 pm
- Forum: Hardware
- Topic: Miracle Hard Drive problem (Hard Disk Replace)
- Replies: 43
- Views: 4976
Hi all, unfortunately all my tricks to recover the old hd is going bad; I've also replaced the rom with the last version and nothing happens so I suppose that all hd's are fault. In effect we are speaking about some pieces of hardware of about 30 years old!! I'm very sorry but I think that we need t...
Right. It also seems to be a fundamental law of something that a chip you have a replacement for is never going to die again ;) Given the high number of Italians here, this seems appropriate: Heeeey, that's a nice 8301 you got there. Would be a shame if something, you know, happened to it... But lo...
And, ignoring the metal contactor plate, that style of switch has become something of an industry standard over the last 35 years or so. I bought a whole pile of them with straight contact springs to work as limit switches on my home CNC machine. OT: have you made the CNC by yourself? I've seen a l...